On Sat, 18 Apr 1998, Nick Ripley wrote:
> >Use the Nemesis-program 'NEMHI_AB.PRG'.
> >
> Oh, I was told not to use this.
It works fine, it's more likely that it's 'NEM_HI.PRG' you're warned
against using.
> >It's not trivial to get Afterburners to work perfectly in 40Mhz. Run
> >in 32MHz instead until things are stable, then start experimenting
> >with 40MHz.
>
> Your not joking. TOS is now unstable with this, so, if I can get back
> into the system for more than a few minutes then I will reset this.
Boot without the ToolKit-driver and reconfigure.
> What suprises me is HOW unstable it all is though.
Some AB's won't even start in 40MHz. However, there are some things
you can do to improve stability:
1. Shield the underside of the AB with aluminium-foil.
2. Shield the wires from the GALs to the AB.
3. Replace the white wire from the Nemesis buffer to the DMA-chip with
shielded wire.
4. You *have* done the resistor/inductor modificiation to the
DMA-chip? (My AB wouldn't even boot until I did this)
/*
** Jo Even Skarstein
http://www.stud.ntnu.no/~josk/
**
** beer - maria mckee - atari falcon - babylon 5
*/
Received on sø. april 19 1998 - 00:47:00 CEST