On Mon, 15 Feb 1999, Laurent FAVARD wrote:
> Joerg Hohwiller a écrit:
>
> > When I switch on, the RGB-Monitor shows a green screen with a black tarten
> > patten. Can anybody help me?
>
> May be, it should be nice to disable your bus speeder, in order to check
> if your Afterburner work well at least alone; because i know that a lot
> of care must be take with the bus acceleration when an AB040 is filled.
>
> What is the speed rate of your board ?
>
mmmhhm! I can select 3 clocks per switch an I selected the normal 16Mhz
one... To remove the speederboard, I will have a lot of work, cause I had
to remove smd-resistors (which are now in the litter and I do not know
which ohm-value they had) and cut a inuctor.
The speed rate can be switched up to 18 or 20 Mhz for the Bus, the
CPU-clock can be singel or double Bus-Clock.
But as I already told, I have set CPU-Clock s-Clock Mhz
Maybe I will buy a dec-alpha 533Mhz and install Linux *resign*
bye Joerg
Received on on. feb. 17 1999 - 11:54:08 CET
This archive was generated by hypermail 2.3.0
: ti. nov. 03 2015 - 20:07:54 CET